• Meets BPIR regulation
• 316 stainless
• Flush finish.
• Larger head to reduce pull-through on larger softwood boards which may experience more movement.
• Heads look uniform across screws, unlike Square Drive heads which need to be lined up to achieve a uniform look.

Applications

• Commonly used for both soft and hardwood wide board decking up to 30mm thick.

Tips for use

• Use Quick Cut for counter sinking/ drilling pilot hole. 4mm Max Torsion tip to drive screw.
• Pre-drilling may be required and recommended for hardwood and board ends.

Note: Screw length depends on the thickness and type of the material you’re working with. Consult a Licensed Building Practitioner (LBP) to determine the best screw length for your application.

NB: These guidelines should be read in conjunction with the New Zealand Building Code (NZS3602, NZS3604, NZS3605, NZS3640 and NZS4203).

Note: Stainless steel fasteners embedded in some high tannin timbers such as Garapa may cause localised tannin stains on the surface of the timber. This risk is reduced by using 316 stainless steel screws (and not 304 stainless steel) and using un-coloured screws (not bronze or black stainless steel options).

Bronze finish is a 'vintage' look and may wear off when installed in high traffic areas, cleaned with abrasive methods or damaged during installation.

Anzor Stainless Steel Decking Screw Brochure